Standing Seam Metal Roof Flashing

High performance for metal roof applications.

Standing seam metal roof flashing.

The most common flashing for standing seam roofing is the ridge cap which is used at the peak of a roof where two opposing roof slopes join and attaches to the roof with z flashing. Buy direct from manufacturer home owners welcome any size order call today. Other flashings include gable trim which runs up the sloped ends of the roof and drip edge or eave trim. Epdm material protects against weathering.

The panels can be roll formed at the job site or at your local roofing materials supply warehouse. Available trim and flashing for standing seam metal roofing panels. For standing seam it s much more complex and labor intensive and may include. Supplied with appropriate screws and sealant.

The video features union s advantage lok ii standing seam roofing panel which is a 16 wide snap lock nail flange panel that is excellent for residential and light commercial applications. End cap flashing standing seam roof ssr. Standing seam consists of sheet metal roofing panels joined side by side and attached to the roofing deck with concealed fasteners. The connecting point where the two separate metal panels meet forms a vertically pointed rib or a seam that is one inch to inch and a half high.

Flexible to conform to panel profiles. A typical standing seam panel can be approximately 12 16 and 19 inches wide. Aligning the panels and. On site rollforming of the metal coil to form panels appropriately spacing clips on the seam per the manufacturer s requirements fastening the clips down to the roof deck for snap lock systems.

High temperature silicone material and retrofit available. Many details in a standing seam metal roof have folds or hemmed edges that conceal the cut edge of the metal.