As most building these days are using those pre made trusses on the roof 24 inches become the main size for any roofing construction when it comes to its truss installation.
Steel roof truss spacing.
The same concept holds true for roof trusses.
Truss spacing for metal roof.
It all comes down to engineering.
Typical roof truss spacing means that they are usually about 24 inches from centre which means at the centre of one truss there will be a two foot gap or twenty four inch gap until the centre of the next truss.
If purlins are laying flat on top of the truss 5 or 6 feet is the max on 2x4 s edge up can go to 12 feet or more.
The manufacturers of the steel roof truss plates also referred to as gussets or gang nails provide the engineering design for pre fabricated wood trusses.
Roof trusses were usually produced on site in the past.
Common spacing for trusses on this type of building is often between 2 and 4 feet but trusses built with advanced designs may allow spacing as great as 8 or 12 feet.
Engineers have since determined however that the physical design of a post frame building will allow for standard spacing as great as 12 feet from the center when using high quality metal connector plates and lumber.
The typical standard for the spacing on the roof trusses is 24 inches.
Their programs will allow for trusses to be placed on 12 foot or even 16 foot centers and their engineers will place their engineer s seal on the drawings to verify.
These standards are as follows.